Now there are more and more various mechanical equipment on the market, including some high-precision mechanical equipment. Their emergence is the confirmation of scientific and technological progress. Slicer is a common equipment, and it should be lubricated on time when it is used.
There are many parts that need lubrication in the slicer, and the lubrication media used are also different, such as the lubrication and grease of its clutch, spring, sprocket tensioning device, reciprocating guide shaft, opening and closing mechanism, etc.
The lubricating oil of the position block cam device and the main transmission chamber in the slicer shall be added, and the oil shall be changed once every six months, which is determined by the clarity of the window oil; Lubricate the angle divider once every half a year; Air compressor lubrication, once every three months.
In addition to lubrication, pay attention to dust prevention, cleaning and electrical faults when using it. In addition to these, its oil change is also very important. It is necessary to ensure the spacing between the four angles of the platform and the cleaning platform. Only by maintaining the correct spacing can the machine operate normally.
When slicing with the slicer, pay attention not to put a large number of waste paper edges and paper wool into the chain drive part, the moving platform of the die cutting part and some other rotating parts, so as to avoid operation failure and damage to the slicer. If the machine is not well maintained during daily use, it will not only increase the cost of repairing the machine, but also cause great damage to the machine.